Connect The Power Cord - HP A3550A - High Availability Disk Arrays Model 20 Storage Enclosure User Manual

Connect the Power Cord

Note The disk array must be installed into the cabinet so that the disk array's fan pack door
can be swung open without interfering with any cables, cabinet PDU, plug on the PDU,
or other devices installed in the cabinet. The PDU should be installed on the left side
of the cabinet (as viewed from the back of the cabinet).
The correct, right angle power cord must be used. If an incorrect power cord is used,
the fan pack cannot be opened without powering down the disk array and
disconnecting the power cord.
A. Push power switch to
OFF (0) position.
B. Plug power cord into
power connector.
Figure 3-5 Connecting the Power Cord (typical)
3-18 Connect the Power Cord
Back of storage system
Note: Fan not shown
for clarity