Related Manuals for IDW G-7
Summary of Contents for IDW G-7
- Page 1 Instruction Manual w w w . i d w - u s a . c o m 990 N. Amelia Ave., San Dimas, CA 91773 | toll free: 877.307.2665 | office: 909.447.8254 | fax: 909.305.8756...
- Page 2 Instruction Manual...
-
Page 3: Table Of Contents
FOR YOUR FUTURE REFERENCE • Thank you for using our product. This manual will guide you in getting the best use of your cooler. • Remember to record the model and serial number located on the back of the cooler. •... - Page 4 Instructional Manual PARTS (Model SC-148/G-7) Glass Door 16. Top hinge cover Horizontal light cover for glass door 17. Upper hinge Glass door seal gasket 18. Cabinet Upper Flat shelf 19. Compressor Shelf strip (short/long) (2/2) 20. Compartment grill Shelf clip (6) 21.
-
Page 5: Safety Instructions
SAFETY INSTRUCTIONS When using this appliance, always follow the basic safety precautions: Read the entire User’s Manual before operating this appliance. Use this appliance only for its intended purpose as described in this User’s Manual. This cooler must be properly installed in accordance with the installation instructions before being used. See grounding instructions on page 4. -
Page 6: Installation
Instructional Manual INSTALLATION Ambient Environment • Place cooler on an even surface to reduce vibration and noise. • To transport, do not tilt the cooler beyond a 45 degree angle. • Do not place cooler in direct sunlight or near any heat sources. •... - Page 7 Leveling/Location • Place unit in a well-ventilated area. WARNING: Warranty is void if ventilation is insufficient. • For proper operation, place the cooler on a dry, level surface • Unit must be leveled for proper operation, this will help prevent condensation. •...
- Page 8 Instructional Manual Removal of Light Canopy and Instruction • The top-placed independent light canopy is removable in the G-7 cooler. Unplug the cooler, then unscrew (6) Screws using a Phillip’s screwdriver. Pull the LED light strip out of its protective cover.
- Page 9 Lamp Decoration, Illumination and Switches • There are LED lights inside the top of the cabinets and in the door. G7 coolers have top canopy lights and inner side lights. Replacement of LED Lights in the Door Unplug the cooler. Remove plastic cover.
-
Page 10: Start
Instructional Manual Startup, Operation and Temperature Adjustment Operation • Prior to stocking cooler with product, it should be operated empty for a half an hour. Temperature Adjustment • It is recommended that the thermostat is set position 3 for the most efficient performance. REPAIR AND MAINTENANCE FOR REFRIGERATION COMPONENTS * A CERTIFIED TECHNICIAN IS REQUIRED TO REPAIR ALL REFRIGERATION COMPONENTS FOR WARRANTY PURPOSES. -
Page 11: Condenser Maintenance
Condenser Maintenance • It is essential to keep the condenser coils clean and free of dust and debris at all times. • It is required to periodically clean the condenser coils with a soft bristle brush or vacuum-cleaner to properly maintain the refrigeration system. •... -
Page 12: Maintenance
Instructional Manual MAINTENANCE Cleaning Shutdown Questions and Answers Cleaning • Unplug the cooler before cleaning. • Use a soft cloth or sponge with water or soap (non-corrosive mild detergent), while cleaning. After cleaning, wipe the cooler using dry cloth to keep the cooler from rusting. •... - Page 13 Issues Solutions Cooler is not functioning. Please check power supply: • Fuse damage • The plug is not securely inserted into the wall socket • Check for low voltage Cooler is not keeping product cool. • Provide ample space between all products to ensure proper circulation of air.
-
Page 14: Warranty
Instructional Manual 134A Compressor Warranty The four year compressor warranty detailed above will be voided if the following procedure is not carefully adhered to: This system contains R134A refrigerant and polyol ester lubricant. The polyol ester lubricant has rapid moisture absorbing qualities. If long exposure to the ambient conditions occur, the lubricant must be removed and replaced with new. - Page 15 ALTERATION, NEGLECT, ABUSE, MISUSE, ACCIDENT, DAMAGE DURING TRANSIT OR INSTALLATION, FIRE, FLOOD, ACTS OF GOD. IDW is not responsible for the repair or replacement of any parts that IDW determines have been subjected after the date of manufacture to alteration, neglect, abuse, misuse, accident, damage during transit or installation, fire, flood, or act of God.
- Page 16 Innovative DisplayWorks, Inc. 990 N. Amelia Avenue, San Dimas, CA 91773 toll free: 877.307.2665 office: 909.447.8254 fax: 909.305.8756 www.idw-usa.com...