Installation; Electrical Requirements - IDW G-7 Instruction Manual

User manual
Table of Contents

Advertisement

Instructional Manual

INSTALLATION

Ambient Environment
Place cooler on an even surface to reduce vibration and noise.
To transport, do not tilt the cooler beyond a 45 degree angle.
Do not place cooler in direct sunlight or near any heat sources.
Do not place cooler in environment temperatures that exceed 109°F.
Do not place cooler in below normal temperatures.
Do not place cooler in extreme humid environments, this may cause components to rust.
Do not place cooler near constant running or splattering water, this may cause immediate damage to
refrigeration system.
Must allow at least 2" between rear of cooler and wall for proper ventilation and heat dissipation of
cooler.
Do not place furniture or other articles with sharp edges near the cooler in order to prevent damage to
the glass door.
PREPARATION PRIOR TO OPERATION
Unpackaging
Remove all packaging materials before using cooler.
This includes: foam pedestal, adhesive tape (used to fix accessories) and protective gaskets.
Inspect cooler for concealed damage. Immediately file a claim with the freight carrier if there is damage.
IDW is not responsible for damage incurred during shipping.
Cooler must remain unplugged in an upright position for 1 hour prior to use.
Clean the interior surface with a soft cloth and lukewarm water before operation.
Ensure that drain hose or hoses are positioned in the pan.
Remove plug and cord from inside the lower rear of the cooler.

Electrical Requirements

This model operates with a 110V/60Hz power supply. Check the electrical outlet for proper voltage.
Dedicate one outlet for the use of the cooler.
Do not use an extension cord or any other multiple connectors as this can lead to compressor failure.
If the cord is damaged, it must be replaced.
For your safety, plug the unit into a grounded wall outlet. Please check with a certified electrician for
details.
WARNING: Do not use extension cords.
WARNING: Compressor warranties are void if compressor burns out due to low voltage.
WARNING: Power supply cord should not be removed!
4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sc-148

Table of Contents