Table of Contents
Advertisement
Selector
No.
1
Not used.
Default reduction rate for failure
2
of automatic reduction during
recording
3
Not used.
4
Minimum short-OFF duration in
5
distinctive ringing
6
Not used.
|
8
Selector 2:
Default reduction rate for failure of automatic reduction during recording
This selector sets the default reduction rate to be applied if the automatic reduction function
fails to record one-page data sent from the calling station in a single page of the current re-
cording paper.
If it is set to "0," the equipment records one-page data at full size (100%) without reduction; if
it is set to "1," the equipment records it at half size (50%).
Selector 5:
Minimum short-OFF duration in distinctive ringing
The ringer pattern consists of short and long rings, e.g. short-short-long rings. This selector
sets the minimum OFF duration following a short ring in order to avoid missing ringer tones
in distinctive ringing.
If this selector is set to "1," when the short-OFF duration is a minimum of 90 ms long, then
the equipment will interpret the short-OFF as OFF.
Selector
No.
1
|
Not used.
4
5
Default resolution
6
7
Default contrast
8
Selectors 5 and 6: Default resolution
These selectors set the default resolution which applies when the equipment is powered up
or completes a transaction.
Selectors 7 and 8: Default contrast
These selectors set the default contrast which applies when the equipment is powered up or
completes a transaction.
WSW31
(Function setting 9)
Function
WSW32
(Function setting 10)
Function
V – 43
Setting and Specifications
0: 100%
1: 50%
0: 130 ms
1: 90 ms
Setting and Specifications
No. 5
6
0
0
:
Standard
0
1
:
Fine
1
0
:
Super fine
1
1
:
Photo
No. 7
8
0
0
:
Automatic
0
1
:
1
0
:
Super light
1
1
:
Super dark
Advertisement
Chapters
Table of Contents
Troubleshooting
