Table of Contents
Advertisement
3-6. Install the included 12-volt battery into the transmitter.
3-7. Cut the lead wires from the fan a maximum length of 3-1/2 inches
from the top of the downrod or the motor adapter (depending on
the mounting method you selected.). Using wire strippers on the
22AWG setting, strip 5/16 inch from each lead wire coming from
the fan.
3-8. Identify the shorter wires coming out of the remote receiver. Using
the small wire nuts provided, connect the shorter receiver wires to
the matching colored wires coming out of the fan. To connect the
wires, hold the bare metal leads together and place a small wire
nut over them, then twist clockwise until tight.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
Note that you will use the longer black wire and white wire
coming from the remote receiver later when wiring to the power
wires from the ceiling. You will connect all the ground wires later
too.
CAUTION: e remote control device complies with part 13 of the FCC rule.
Changes or modifications not expressly approved by Hunter Fan Company could void
your authority to operate this equipment.
Operation is subject to the following two conditions:
1. is device may not cause harmful interference.
2. is device must accept any interference received, including interference that may
cause undesired operation.
Note: Use with a fan that incorporates an air gap switch (normal on-off wall switch).
WARNING: Maximum fan load is 100 Watts; maximum lamp is 300 Watts. Do not
use any speed control with this product.
41869-01 • 03/12/04
Small Wire Nut
Hunter Fan Company
7
Advertisement
Table of Contents
