Epson PP-100N - Discproducer - DVD Duplicator x2 User Manual page 156

Error Message
Print tray
open/close error
Printer maint.
error
Replace ink
(C,LC,LM,M,Y,K)
Replace inkpad
Stacker 3
installed
Stacker 3
not installed
Stacker 4 full
Stacker 4 open
Stacker full
ST2,ST3,ST4
Too many discs
ST1,ST2,ST3
Transferred disc
detection error
Wait a moment
and try again
Write error
156
Remedy
-When the printer tray does not come out-
See "Printer Tray Does Not Come Out" in the PP-100N
Administrator's Guide.
-When the printer tray does not close-
Remove any remaining discs, turn off the power, and then
turn on the power again.
If the same error message still appears, repair is required.
Please contact Customer Support.
Repair is required.
Please contact Customer Support.
The ink in the cartridge is out.
Replace the cartridge of the displayed color. (See
"Changing the ink cartridge" on page 131 in this guide.)
It is time to replace the ink pad.
Please contact Customer Support. The ink pad cannot be
replaced by the customer.
Remove Stacker 3, and close the disc cover. Stacker 3 is not
used in Standard Mode/External Output Mode.
Load Stacker 3, and close the disc cover. Stacker 3 is used in
Batch Mode.
The initialization operation cannot be performed because
Stacker 4 is full.
Remove the discs from Stacker 4.
Close Stacker 4.
The disc cannot be ejected because the output stacker is
full. Remove the discs from the output stacker (Stacker 2,
Stacker 3, or Stacker 4).
Remove excess discs so that the height of the discs in the
indicated stacker is below the red line of the stacker, and
then close the disc cover.
A disc could not be detected after transfer to a printer or
drive. Turn off the power, and then turn it on again. If the
same error message still appears, repair is required. Please
contact Customer Support.
Press the button or CANCEL button. Do not unlock the
disc cover repeatedly within a short time. Wait a moment
before unlocking.
Processing of the job is paused. See "Disc writing problems"
on page 159 in this guide, and after removing the cause of
the error, restart the job. (See "Resuming jobs" on page 115 in
this guide for the job restarting procedure.)
Notification
Sound