Table of Contents
Advertisement
Assembly Instructions for Integrated Dishwasher
Technical Information for Installation
The control panel (except in the completely built-in version) can
be easily aligned with the kitchen drawers, using the spacers sup-
plied with the appliance ( see Fig.1 and Fig.2).The height of the
control panel is 115 mm, while the three spacers each add 7.5
mm in height.
Adjusting the Height of the Control Panel
If the kitchen decor requires that the height of the panel be modi-
fied , it can be increased by adding spacers at the bottom of the
control panel itself (see Fig.1 and Fig.2). Each spacer adds 7.5
mm in height.
Mounting the Wooden Panel onto the Door and
Sliding the Dishwasher into the Cabinet
During the preparatory stages for installing the dishwasher into
the kitchen cabinet, holes must not be drilled in the sides, or door,
in order to avoid compromising the performance and/or operation
of the appliance. Before working on any internal components, the
unit must be disconnected from the power supply .The maximum
dimensions for the wood panel that can be installed on the door
are: Height - 725 mm for the completely built-in version; Width -
448 mm; Thickness-20 mm.
The height dimension of 725 mm must be reduced if the height of
the control panel is increased through the use of the spacers. In
addition, the base must be trimmed if it interferes with the open-
ing of the door.
Using the Drilling Template (Fig.3 - totally built-
in and Fig.4 - integrated with control panel )
Align the top edge of the template (identified with the "A" arrow )
with the top edge of the panel. On both sides of the template (top
and bottom ) are written the various dimensions that correspond
to the different possible widths for the panel. Align the template
with the side of the panel (left or right), making sure that the panel
coincides with the appropriate dimensions. Mark the positions for
the holes for the screws, using the tip of a drill or a pencil. The
three holes closest to the side should be used(B). Repeat this
step on the other side of the panel ,using the corresponding side
of the template.
B
A
mm
B
115
122.5
130
A
137.5
145
152.5
582mm
586mm
590mm
594mm
LARGH.=598mm
LARGH.=598mm
594mm
590mm
586mm
582mm
en
Fig.1
Fig.2
Fig.3
Fig.4
8
Advertisement
Table of Contents
