How To Fill Rinse Aid; How To Fill The Detergent Dispenser - Haier DW12-TFE3ME Instructions For Use Manual

How to fill rinse aid

Rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door .
When the low rinse aid indicator
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your appliance,
you must proceed as indicated below when loading the rinse aid.
To open the dispenser, turn the
and then pour in the rinse aid, making sure not to overfill. The amount of
rinse aid used for each cycle can be regulated by turning the "
adjustor, located beneath the
different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-
ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white
streaks, turn the dosage adjustor to a lower setting.

How to fill the detergent dispenser

Detergent
Detergent specifically intended for use with dishwashers must be used.
The dispenser must be refilled before the start of each wash cycle
following the instructions provided in the "Programme overview". The
detergent dispenser is located on the inside panel of the door.
Loading the detergent
To open the " 4 " cover on the dispenser, press the
The detergent for the wash cycle should be poured into the " 6
compartment.
The detergent for the pre-wash cycle should be poured into the
" 7 " compartment.
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any excess detergent on the edges of the dispenser.
9
"H" lights, you must load rinse aid .
"2" cap in an anti-clockwise direction
"2" cap, with a screwdriver. There are 6
"5"
3" dose
5
4
button.
"
6
en
H
2
3
7