Telephone Base And Charger Installation - AT&T EL51209 - DECT 6.0 Quick Start Manual

Telephone base & charger installation
Install the telephone as shown below. The telephone base is ready for table
use.
5. Plug the other end
of the telephone
line cord into a
telephone jack or a
DSL filter.
4. Plug the large end
of the AC power
adapter into a
power outlet not
connected to a wall
switch.
3. Route the power
adapter cord
through the slot.
Charger installation
Plug the AC power
adapter into a power
outlet not controlled
by a wall switch.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
If you have DSL high speed
Internet service, a DSL filter
(not included) is required.
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
4
1. Plug one end of
Telephone line cord
2. Plug the small
the telephone
line cord into
the telephone
jack on the
bottom of the
telephone base.
end of the AC
power adapter
into the power
jack on the
bottom of the
telephone base.
, or call
.