Completing The Installation; Replacing The Bezel - IBM System x3400 Type 7975 Installation Manual

Completing the installation

To complete the installation, you must replace the bezel, reinstall the side cover,
and connect all the cables and, for certain options, run the Configuration/Setup
Utility program. Follow the instructions in this section.

Replacing the bezel

To replace the bezel, complete the following steps:
1. Align the hinge assembly with the hinge holes on the chassis.
2. Push the hinges into the holes on the chassis until they snap into place.
3. If however, the bezel was removed by detaching the sliding hinge mount from
Hinge assembly
the hinge assembly (using the breakaway method as the bezel was designed to
do), complete the following steps to reattach the bezel:
a. Press in on the rear of the sliding hinge mount until it extends beyond the
edge of the bezel and hold it in place.
Bezel
Retention tabs
Chapter 2. Installing options
31