Electrolux EW30EC55G - 30" Electric Cooktop Installation Instructions Manual page 6

Cooktop Installation
1. Visually inspect the cooktop for damage. Also make
sure all cooktop screws are tight (see Figure 6).
3. Set the cooktop into the countertop cutout.
NOTE: Do not use caulking compound; cooktop should
be removable for service when needed.
Screws
Figure 6
2. Install the retainer brackets. See Figure 7
The retainer brackets MUST be installed, to meet
local codes or, in their absence, with the National
Electrical Code ANSI/NFPA No. 70--latest edition
in the United States, or with CSA Standard C22.1,
Canadian Electrical Code, Part 1 in Canada (see
Figure 7).
Cooktop Countertop
spacer
Retainer bracket
Figure 7
Do not remove the nylon spacers on
the edges of the cooktop. These spacers center the
cooktop in the space provided. The cooktop must
be centered to prevent excess heat buildup that
may result in heat damage or fire (see Figure 8).
6 Nylon spacers
Position brackets
. - j_
on unit cutout .: _-_" :
center line ..::::::
2 Retainer _
brackets ..........
Figure 8
Granite countertop Installation Kit
A Granite Countertop Installation kit # 903061-9010 can
be ordered through a Service Center or by phone at 1-877-
ELECTROLUX (1-877-435-3287).
Checking Operation
Refer to the Use and Care Guide for operation.
Do not touch cooktop glass or elements.
They may be hot enough to burn you.
Model and Serial Number Location
The serial plate is located under the cooktop.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before you Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide.
It may save you time and expense. This includes
common occurences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for sevice phone num-
bers,
6