Advertisement
1-1-2. Removal of Housing (B) of the Housing (A), (B) Set [18] <17> (17)
(1) Cut the Label [29] with a cutter along the groove between the assembled Housing (A) and (B) Sets [18]
(For FDV 16VB only).
(2) Remove the seven D4 x 20 Tapping Screws (W/Flange) [20] <19> (19) and take off Housing (B) of the
Housing (A), (B) Set [18] <17> (17).
Label [29]
(FDV 16B only)
Housing (A), (B) Set [18] <17> (17)
1-1-3. Disassembly of the Armature and Stator
(1) Remove the two Brush Holders [22] <21> (21) by lifting them upward from Housing (A) of the Housing
(A), (B) Set [18] <17> (17), and take out the two Carbon Brushes [20] <20> (20).
(2) With the Change Plate [11] <10> (10), the Change Knob [10] <9> (9) and the Spring (A) [12] <11> (11)
installed, remove the Holder [13] <12> (12), the Armature [15] <14> (14), the Stator [16] <15> (15) and the
Gear [8] <7> (7) all together.
(3) Remove the Spindle [4] <3> (3) and the Gear [8] <7> (7) together from the Holder [13] <12> (12). Be
careful not to lose the Steel Ball D4.76 [9] <8> (8).
(4) By pulling out the Armature [15] <14> (14) from the Holder [13] <12> (12), the Ball Bearing [14] <13> (13)
can be removed together with the Armature. Remove the Ball Bearing from the Armature with the
bearing remover.
(5) Remove the Internal Wires [24] [26] [35] [36], <22> <23> <31> <32>, (22) (23) (31) (32) and the Choke Coils
[23] [27] from the Stator [16] <15> (15).
1-1-4. Disassembly of the Holder, Gear and Spindle
(1) Remove the Change Plate [11] <10> (10), the Change Knob [10] <9> (9) and the Spring (A) [12] <11>
(11) from the Holder [13] <12> (12).
(2) By pushing the Spindle [4] <3> (3) toward the chuck while holding the chuck side surface of the Gear
[8] <7> (7), the Gear can be removed. By removing the D12 Retaining Ring [7] <6> (6) from the Spindle
[4] <3> (3), the Spring [5] <4> (4) and Ball Bearing [6] <5> (5) can be removed.
Groove
Housing (A)
Cut with a cutter
(FDV 16VB only)
2
Housing (B)
Advertisement
