Advertisement
Ball Bearing
608VVMC2EPS2L
[14] <13> (13)
1-2-2. Reassembly of the Holder
(1) When installing the Change Plate [11] <10> (10) and Spring (A) [12] <11> (11) to the Holder [13] <12> (12),
be careful of the direction of each part.
(2) Insert the Armature [15] <14> (14) and the gear spindle ass'y into the Holder [13] <12> (12), and insert
them into the Stator [16] <15> (15). Be sure to reassemble the Steel Ball D4. 76 [9] <8> (8) at this time.
Apply ATTOLUB MS No.2 to the ball chamber of the Spindle [4] <3> (3) and then reassemble the Steel
Ball D4.76.
(3) Install the reassembly from the above step (2) in the Housing (A) of the Housing (A), (B) Set
[18] <17> (17). Check that the fan of the Armature [15] <14> (14) can be turned freely by finger.
1-2-2. Other
When re-mounting Housing (A) of the Housing (A), (B) Set [18] <17> (17), be very careful to ensure that the
lead wires are not excessively slack, and that they are not pinched between components during
reassembly.
0
123.8
-0.3
Armature
Fan
[15] <14> (14)
Spring (A)
[12] <11> (11)
Ball Bearing
626VVMC2ERPS2LS [17] <16> (16)
Stepped portion of shaft
Change Plate [11] <10> (10)
Ratchet
Holder [13] <12> (12)
4
Advertisement
