Displaying The Picture - Hitachi CP-DW10N Operating Manual

Displaying the picture

1. Activate your signal source. Turn the signal
source on, and make it send the signal to
the projector.
2. Use the VOLUME + / VOLUME - buttons
to adjust the volume.
To have the projector silent, press the MUTE
button on the remote control.
3. Press the INPUT button on the projector.
Each time you press the button, the
projector switches its input port in turn.
You can also use the remote control to
select an input signal. Press the VIDEO
button for selecting an input signal from the
S-VIDEO or VIDEO port, or the COMPUTER
button for selecting an input signal from the
COMPUTER IN1, COMPUTER IN2 or HDMI
port.
4. Press the ASPECT button on the remote
control. Each time you press the button,
the projector switches the mode for aspect
ratio in turn.
Use the focus ring to focus the picture.
5.
CAUTION
Any other method of blocking the projection light,
such as attaching something to the lens or placing
something in front of the lens, may cause the
damage to the projector.
NOTE The ASPECT button does not work when no proper signal is inputted.
in the CD.
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH
MAGNIFY FREEZE PAGE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON
1 2
POSITION
ENTER
ESC
INPUT button
MY SOURCE/
VIDEO COMPUTER DOC.CAMERA
ASPECT AUTO SEARCH
PAGE
MAGNIFY FREEZE
UP
ON
DOWN
OFF
KEYSTONE MY BUTTON
1 2
POSITION
ENTER
ESC
11
BLANK
VOLUME
VOLUME+ button
VOLUME- button
MUTE
MUTE button
MENU
RESET
DBY/ON INPUT
VIDEO button
COMPUTER button
BLANK
VOLUME
ASPECT button
MUTE
MENU
RESET
MEN