Restore Defaults - Oki B4200 User Manual

Section 6 - Chapter 2 - The OkiLAN 6020e Utility
Enable Port
This option allows you to enable or disable a port. If a
port is disabled, it will appear in the OkiLAN 6020e
utility but will not appear in the Chooser. A disabled
port cannot be configured. The only valid options for a
disabled port are Status, Enable Port, Print Config, and
Restore Defaults. A port should be disabled when no
printer is attached.
Note: It is possible to disable all ports but this is not
recommended. The EtherTalk protocol will still
be active on the network. To disable the
EtherTalk protocol, use a utility from one of the
other protocols.
Reset Board
This option will reset the print server.

Restore Defaults

This option will automatically return the EtherTalk
interface to its factory defaults. All ports will be
restored to factory defaults.
The following OkiLAN 6020e variables will restore to
default:
Name: OKI <serial number> Port <port number>
(for single port products, the port number will not
be shown)
Type 1 = LaserWriter
Type 2 = (None)
Zone = Default - (The default zone for the network
segment will be used)
Port Enabled = Yes
OKI OkiLAN 6020e User's Guide VI - 7