Regarding The Indicator Lamps - Dukane 8063 User Manual

Troubleshooting

Regarding the indicator lamps

Lighting and flashing of the POWER indicator, the LAMP indicator, and the TEMP
indicator have the meanings as described in the table below. Please respond
in accordance with the instructions within the table. If the same indication is
displayed after the treatment, or if an indication other than the following is
displayed, please contact your dealer or service company.
POWER LAMP
indicator indicator
Lighting Turned
In Orange off
Blinking Turned
In Green off
Lighting Turned
In Green off
Blinking Turned
Orange off
In
Blinking (discre-
In Red tionary)
Blinking
In Red
Lighting
or
In Red
Lighting
In Red
Blinking
In Red
Blinking
or
In Red
Lighting
In Red
44
TEMP
indicator
The projector is in a standby state.
Turned
off Please refer to the section "Power On/Off".
Turned The projector is warming up.
off Please wait.
Turned The projector is in an on state.
off Ordinary operations may be performed.
Turned The projector is cooling down.
off Please wait.
The projector is cooling down. A certain error
has been detected.
(discre-
Please wait until the POWER indicator finishes blink,
tionary)
and then perform the proper response measure using
the item descriptions below as reference.
The lamp does not light, and there is a
possibility that interior portion has become
heated.
Please turn the power off, and allow the unit to cool
down at least 20 minutes. After the projector has
sufficiently cooled down, please make confirmation of
Turned
the following items, and then turn the power on again.
off
• Is there blockage of the air passage aperture?
• Is the air filter dirty?
• Does the peripheral temperature exceed 35°C?
If the same indication is displayed after the treatment,
please change the lamp by referring to the section
"Lamp".
The lamp cover has not been properly fixed
(attached).
Please turn the power off, and allow the unit to cool
down at least 45 minutes. After the projector has
Turned sufficiently cooled down, please make confirmation
off of the attachment state of the lamp cover. After
performing any needed maintenance, turn the power
on again. If the same indication is displayed after
the treatment, please contact your dealer or service
company.
Description