Sagem 3100MFPX - Phaser B/W Laser User Manual page 10

Sagem_Fax_ATA101S.book Page 6 Jeudi, 21. février 2008 5:09 17
Step 3 - SIP Configuration > SIP general > Tel to IP routing table
menu
If you do not use a proxy, you can set up the routing tables via this
menu. The routing tables of the Sagem Fax ATA 101S allow you to
create a routing of type "Tel to IP".
Route the call coming from the analog terminal connected to the
Sagem Fax ATA 101S to a specific IP terminal (IPBX, VoIP gateway,
IP telephone, IP fax machine, etc.) according to the dialled number
prefix.
1. To create a routing table click on Add.
The following window is displayed:
1. In the Speed dial field, enter the code used to detect the routing
table to be used when the user dials a number starting with this
code. This code can contain one to three digits.
2. In the User name and IPv4 addr fields, enter the information
relating to the VoIP peripheral to which the call is to be routed.
You can also define the communication port (the ATA default port
proposed is the port normally used by the SIP protocol).
3. To validate, click on Add.
The new routing rule is then created.
6 Sagem Fax ATA 101S