Biostar P4TPT Bios Setup Manual page 22

P4TPT BIOS Setup
Video Off In Suspend
This determines the manner in which the monitor is blanked.
The Choices: Yes (default), No.
Suspend Type
This item allows you to select the legacy suspend mode method.
The Choices: Stop Grant, PwrOn Suspend (default).
MODEM Use IRQ
This determines the IRQ, which can be applied in MODEM use.
The Choices:3 (default)
Suspend Mode
When enabled and after the set time of system inactivity, all devices except the CPU will be
shut off.
The Choices: Disabled (default), 1Min, 2Min, 4Min, 8Min, 12Min, 20Min,
HDD Power Down
When enabled and after the set time of system inactivity , the hard disk drive will be
powered down while all other devices remain active.
The Choices: Disabled (default), 1Min, 2Min, 3Min, 4Min, 5Min, 6Min, 7Min,
.
Soft-Off by PWR-BTTN
Pressing the power button for more than 4 seconds forces the system to enter the
Soft-Off state when the system has "hung."
The Choices: Delay 4 Sec, Instant-Off (default).
CPU THRM-Throttling
Select the CPU THRM-Throttling rate.
The Choices: 87.5%, 75.5%, 62.5%, 50.0% (default), 37.5%, 25%, 12.5%.
Wake-Up/Power On Control
If you highlight the literal "Press Enter" next to the "Wake-Up/ Power On Control" lable
and then press the enter key, it will take you a submenu with the following options:
Wake-Up by PCI card
When you select Enable, a PME signal from PCI card returns the system to Full
On state.
The Choices: Enabled, Disabled (default).
4 / 5 / 7 / 9 / 10 / 11 / NA
30Min, 40Min, 1Hour.
8Min, 9Min, 10Min, 11Min, 12Min, 13Min, 14Min, 15Min.
21