Advertisement
Three
wire power
supply
cord
must
have
three,
No.-10
copper
wires and match
a
three-wire
receptacle
of NEMA Type
I0-30R.
Three-wire
receptacle
Where local codes permit
connecting cabinet-ground
conductor to neutral wire:
4.
Loosen
or remove
block
screw,
_. Connect the neutral wire
center) of power supply cord to the
center, silver-colored terminal screw of
the terminal block. Tighten screw•
6. Connect the other wires to outer _
terminal block screws. Tighten screws.
7, Tighten
strain
relief screws.
8. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover with
hold down screw.
OI
wire
reenter)
Where local codes permit
connecting cabinet-ground
conductor 1o neutral wire:
4.
Loosen or remove center terminal
block screw.
5. Place the hooked end of the neutral
wire (white or center) of power supply
cable under the center screw of the
terminal block (hook facing right).
Squeeze hooked end together. 7]ghten
screw.
6, Place the hooked
ends of the other
power
supply
cable wires under
the outer
terminal
block
screws (hook
facing
right).
Squeeze
hooked
ends together.
Tighten
screws.
7. Tighten
strain relief
screws_•
8. Insert tab of terminal block cover into
slot of dryer rear panel. Secure cover with
hold-down
screw.
I
i
Three-wire
power supply cord must have
three, No.-10 copper wires and match a
three-wire receptacle of NEMA Type 10-
SOR.
Direct
wire
power
supply
cab e mus
be
prepared
as shown
in "Preparing
the wire"
,
of the three wire connection
direct-wge
steps above.
Where local codes Do Not permit
connecting
cabinet-ground
conductor to neutral wire:
9. After reattaching
the terminal cover,
connect a separate copper ground wire from
4.
Remove center terminal block screw,
the external ground connector screw to an
adequate ground.
5, Remove the appliance harness ground
wire (green with yellow stripes) from the
external ground connector screw.
Connect appliance harness ground wire
and the neutral wire (white or center) of
the power supply cord/cable
under the
center, silver-colored
terminal block screw.
Tighten screw,
6. Connect the other wires to outer
terminal block screws, Tighten screws.
7, Tighten strain relief screws._
8,1nsert tab of terminal block cover into
__
.If"'_f" "
slot of dryer rear panel. Secure cover with
_
_
hold-down screw,
cover with
Panel E
Advertisement
