Using Multi Operations; Using System Off - Pioneer ELITE VSX-92TXH Operating Instructions Manual

Controlling the rest of your system
12
Use / to select a command in the sequence then
5
press ENTER.
If this is the first command in the sequence, select 1ST
CODE. Otherwise, simply choose the next command in
the sequence. PRES KEY flashes after you press ENTER.
6 If necessary, press the input source button for the
component whose command you want to input.
This is only necessary if the command is for a new
component (input source).
7 Select the button for the command you want to
input.
The following remote control commands can be selected:
INPUT
RECEIVER
SELECT
CD CD-R
DVD TV
HOME MEDIA
DVR2
GALLERY
DVR1 i Pod
SLEEP
SR+
D.ACCESS
CLEAR
+10
A PARAMETER
TOP MENU  
TUNE
BAND ST
SETUP
TUNE
PROGRAM
CATEGORY GUIDE
TV CONTROL
• You don't need to program the receiver to switch on
or off. This is done automatically.
With Pioneer components, you don't need to:
• program the power to switch off in a shutdown
sequence (except DVD recorders);
• program the power to switch on if it's the source
component selected in step 3;
• program a Pioneer TV or monitor to switch on if the
input function (selected in step 2) has video input
terminals;
These take priority in multi operations (not shutdown).
8 Repeat steps 5–7 to program a sequence of up to
five commands.
When you're finished, use / to select EDITEXIT
9
from the menu and press ENTER.
You will return to the remote control SETUP menu. Select
* EXIT * again to exit.
Note
1 In order to avoid accidently switching off a DVD recorder that is currently recording, no DVD recorder power off codes are sent.
80
En
SYSTEM OFF
SOURCE

XM RADIO HDMI
BD TV CTRL

SIRIUS ZONE2/3
TUNER RECEIVER
DIMMER ANALOG
ATT
GENRE
TV CONTROL
INPUT
TV VOL TV CH
SELECT
CLASS
DISC
CH ENTER
LEVEL
INFO
ANT REC
V PARAMETER
MENU T.EDIT
MPX REC STOP MEMORY
ST
 
ENTER
RETURN
AUDIO SUBTITLE HDD
DISP CH
PHOTO T.DISP
STEREO/
STATUS SIGNAL SEL SBch
F.S.SURR

Using multi operations

You can start multi operations with the receiver switched
on, or in standby.
1 Press MULTI OPE.
MULTI OP flashes in the display.
2 Press an input source button that has been set up
with a multi operation.
The receiver switches on (if it was in standby) and the
programmed multi operation is performed automatically.

Using System off

RECEIVER
VOL
MUTE
1 Press MULTI OPE.
MULTI OP flashes in the display.
DVD
CH
2 Press SOURCE.
The command sequence you programmed will run, then
all Pioneer components will switch off
receiver.
PHOTO T.DISP
STEREO/
STATUS STATUS SIGNAL SEL SBch
F.S.SURR
MULTI OPE THX STANDARD ADV. SURR
SHIFT
PHASE MCACC S.DIRECT
RECEIVER
SYSTEM OFF
PHOTO
INPUT
SOURCE
STATUS STATUS SIGNAL SEL
SELECT
MULTI OPE THX
SHIFT
PHASE

CD CD-R XM RADIO
HDMI RECEIVER
DVD TV BD TV CTRL
HOME MEDIA
T.DISP
STEREO/
SBch
F.S.SURR
STANDARD ADV. SURR
MCACC S.DIRECT
1
, followed by this