Fm Wire Antenna; Connecting External Antennas; Plugging In The Receiver; Ac Outlet - Pioneer ELITE VSX-92TXH Operating Instructions Manual

Connecting your equipment
03

FM wire antenna

• Connect the FM wire antenna to the FM UNBAL
75 Ω in the same way as the AM antenna.
For best results, extend the FM antenna fully and fix to a
wall or door frame. Don't drape loosely or leave coiled up.

Connecting external antennas

To improve FM reception connect an external FM
antenna to the FM UNBAL 75 Ω.
75 Ω coaxial cable
FM UNBAL 75 Ω
To improve AM reception, connect a 5 m to 6 m (15 ft. to
18 ft.) length of vinyl-coated wire to the AM LOOP
terminals without disconnecting the supplied AM loop
antenna.
For the best possible reception, suspend horizontally
outdoors.
Outdoor antenna
FM UNBAL 75 Ω
AM LOOP
22
En
ANTENNA
AM LOOP
Indoor antenna
(vinyl-coated wire)
5 m to 6 m
ANTENNA
(15 ft. to 18 ft.)

Plugging in the receiver

Only plug in after you have connected all your
components to this receiver, including the speakers.
• Plug the AC power cord into a convenient AC power
outlet.
Caution
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
ask your nearest Pioneer authorized independent
service company for a replacement.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular
use, e.g., when on vacation.
• Make sure the blue  STANDBY/ON light has gone
out before unplugging.

AC outlet

Power supplied through this outlet is turned on and off by
the receiver's power switch. Total electrical power
consumption of connected equipment should not exceed
100 W (0.8 A).
Caution
• Do not connect a TV set, monitor, heater, or similar
appliance to this unit's AC outlet.
• Do not connect appliances with high power
consumption to the AC outlet in order to avoid
overheating and fire risk. This can also cause the
receiver to malfunction.
• Since a subwoofer or power amplifier can exceed the
100 W maximum when playing sources at a high
volume, this type of equipment should not be
connected to the AC outlet.