Sharp AR-C200P - Color Laser Printer User Manual page 323

Cannot configure for USB connection.
• Windows 95 does not support USB.
• Windows 98 upgraded from Windows 95 may not support
USB.
• Windows 98 original installation and Windows Me, 2000
and XP all support USB.
Possible Cause
Computer does not
support USB
interface.
USB cable does not
meet specifications.
Interface is disabled.
Configuration
procedure was not
correctly followed or
cancelled.
USB cable is
disconnected or
faulty.
A USB hub is being
used.
Printout is garbled or incorrect with parallel connection.
Possible Cause
Possible mismatch on
parallel connection
between computer and
printer.
NOTE
Remedy
Check if there is a USB controller in the Windows device
manager.
Use USB cable to specification Ver.1.1.
Check that USB interface is set to Enable.
Configure again from the beginning.
Reconnect or try another cable.
The printer cannot be used with a USB hub. Connect the
printer and computer directly.
Remedy
Change parallel transmission mode (see Parallel
Transmission Mode above).
Sharp AR-C200P: Troubleshooting • 323