DM-1505
Main code
Sub code
26
38
Cancel of stop at drum life over
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
39
Memory capacity setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
40
Polygon motor OFF time setup
(Operation/Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed.
42
Transfer ON timing control setup
(Operation / Procedure)
1. When this simulation is executed, the currently set code number is displayed.
2. Enter the code number and press the START key, and the setting will be changed. (For any number different
from the following ones, the default time is automatically set.)
Code number
0
Stop at drum life over
1
Stop cancel at drum life over
Code number
0
No memory
1
4 Mbyte
2
6 Mbyte
Code number
0
0 sec
1
30 sec
2
60 sec
3
90 sec
Code number
0
Default (330 msec)
1
–40 msec
2
–30 msec
3
–20 msec
4
–10 msec
5
Default (330 msec)
6
+10 msec
7
+20 msec
8
+30 msec
9
+40 msec
manuals4you.com
Content
Setting
Setting
Setting
Setting
9 – 6