Ricoh Aficio SP 4310N Hardware Manual page 78

3. Installing Options
7. Push in the duplex unit along the rails at the back of the printer.
3
8. Push the duplex unit securely into the printer.
• After finishing installation, you can check whether the duplex unit is properly installed by printing the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Duplex Unit"
as " Attached Equipment " on the configuration page.
• If the duplex unit is not installed properly, repeat the procedure from the start. If you cannot install it
properly even after reinstallation, contact your sales or service representative.
• If the printing position is not correct, adjust the registration of the trays. For more information about
adjusting the registration of the trays, see p.187 "Adjusting Printing Position".
• When the duplex unit is installed, the rear cover is no longer required. However, we recommend you
keep the cover for future use.
• For details on printing the configuration page, see p.45 "Test Printing".
76
CEE057
CEE050