Managing Ssl Keys - VMware APPSPEED SERVER 1.5 Manual

8 (Optional) Click Back to change any of the settings.
9 (Optional) If you used an AppSpeed Server snapshot to optimize multiple probe deployment, delete the
snapshot after you finish deploying all of the probes.
The installation progress is indicated in the Probe Status column in the Probes Management window.
The probe is added to the
What to do next
When the installation is complete, you can see the new probe in the vSphere Client by navigating to Home >
Inventory > VMs and Templates.
Power Probes On or Off
You can power probes on or off from the Probes Management window.
Procedure
1 In the AppSpeed menu bar, click Administration.
2 In the page selection bar, click Deployment.
3 Select the check boxes for one or more probes and click Power On or Power Off.
Delete Probes
If you do not want to monitor the traffic on a specific host, you can remove the probes. If you do not want to
monitor specific vSwitches on a host, you can delete the probe that is monitoring those switches.
Procedure
1 In the AppSpeed menu bar, click Administration.
2 In the page selection bar, click Deployment.
3 Select the check boxes for one or more probes on one or multiple hosts, and click Delete Probe.
4 Click OK to confirm.
The probe is removed from the selected hosts only.

Managing SSL Keys

To monitor traffic on HTTPS sites that incorporate SSL protection, you must configure the SSL keys for each
endpoint and the IP address and port pair where AppSpeed detects SSL traffic.
AppSpeed supports SSL key monitoring only for HTTPS sites.
VMware, Inc.
folder. The probe is powered on and set up.
namespaceProbes
Chapter 4 AppSpeed Administration
31