Maintenance And Service; Note On Disposal - MINOURA HYPERRIM Manual

After replacing the rollers, you must fix the pulley's upper and lower covers firmly.
5
On the Mag unit side, after applying the pulley you must pull the Mag unit to tension the V-
Belt.
Then, tighten the two bolts while holding the V-Belt in the proper tension.
When you fix the upper and lower roller covers, you must
!
make sure these covers are parallel.
If the covers are not parallel, it may result in vibration that
may loosen the rollers and cause an accident. (see Fig. P)

MAINTENANCE AND SERVICE

• If strange noises or vibration persist, discontinue use immediately and return to your Minoura dealer
or place of purchase for assistance. You may also contact Minoura Co.,Ltd.: 1197-1 Godo, Anpachi,
Gifu 503-2305 Japan, or contact to Minoura North American R&D Center at 1-510-538-8599 or email
to MinouraUSA@ATTglobal.net.
• Always check for tightness of bolts and nuts before using.
• Check V-Belt and couplings for excessive wear or damage.
• Remove all oils and moisture from drive pulleys and other devices.
• Keep dry and out of weather.

NOTE ON DISPOSAL

To dispose of an old or broken trainer, please disassemble as much as possible
!
and recycle properly.
Do NOT dispose of trainer in trash. Harmful gas may occur if burned.
Keep abandoned parts away from children.
- 8 -
(Fig. P)