HYOSUNG GV250 User Manual page 36

3. Loosen the front axle pinch bolt ② .
4. Loosen the front axle ③ .
5. Carefully position a jack or block under
engine and raise until the front wheel is slight-
ly off the ground.
CAUTION
Improper jaking may cause damage to the
oil filter.
Do not apply the jack head to the oil filter
when jacking up the motorcycle.
6. Draw out the axle shaft.
7. Slide the front wheel forward.
8. To reinstall the wheel assembly, reverse the
sequence as described.
◉ REAR TIRE REPLACEMENT
1. Place the motorcycle on the center stand.
①
2. Remove the two screw ① and chain case.
④
3. Remove the brake adjuster nut ② , and place
a jack or block under the swing arm to lift the
rear wheel slightly off the ground.
36
③
②
③