User Mode; Enter The User Mode; Changing The Status Of A Transmitter; Exiting The User Mode - Honeywell 6150RF - Ademco Deluxe Fixed Keypad/Receiver User Manual

Keypad/transceiver

Hide thumbs Also See for 6150RF - Ademco Deluxe Fixed Keypad/Receiver:

Table of Contents

User Mode

This mode gives you the capability of enabling and disabling individual wireless keys that have been

directly programmed into the ADEMCO 6150RF. This is particularly useful if a user loses a wireless

key.

This mode may only be accessed if the ADEMCO 6150RF is powered up for at least 1 minute.

Only wireless keys programmed directly into the ADEMCO 6150RF may be enabled and

disabled using this mode.

Press the [1] and [3] keys simultaneously for a few seconds (make sure the unit has been

powered for at least 1 minute prior).

On the display, "dE" and "-" flashes alternately. Enter the number of the wireless key

transmitter (1-8).

Then "d" and the wireless key number you entered flash alternately with "1" or "0" on the

display. A "1" indicates the wireless key is enabled, a "0" indicates it is disabled. Enter [1] to

enable or [0] to disable the wireless key. All wireless keys are defaulted to 1 (enabled).

Press the [✳ ✳ ✳ ✳ ] to accept the entry.

Repeat the procedure for all the wireless keys whose status you want to change.

To exit the User mode press [✳ ✳ ✳ ✳ ] when "dE" and "–" flash alternately on the display.

ÊK4461-1V1eŠ

K4461-1V1 4/05 Rev. A

165 Eileen Way, Syosset, New York 11791

www.honeywell.com/security

Table of Contents

Do you have a question about the 6150RF - Ademco Deluxe Fixed Keypad/Receiver and is the answer not in the manual?