Removing And Replacing The Speaker - IBM 8183 - ThinkCentre S50 User Manual

10. Use the IBM Setup Utility program to set the date and time and any

Removing and replacing the speaker

To replace the speaker:
1. Turn off the computer and disconnect the power cord from the electrical outlet
2. Open the cover. See "Opening the cover" on page 10.
3. Rotate the drive bay assembly upward to gain access to the speaker.
4. Locate the speaker 1 . See Figure 1 on page 41.
5. Disconnect the speaker cable from the system board. See "Identifying parts on
6. Remove the speaker by sliding the it upward and out of the retaining bracket.
7. Install the new speaker and reconnect the speaker cable.
40
User Guide
4. Remove the PCI riser and PCI adapters that impede access to the battery.
5. Remove the old battery.
6. Install the new battery.
7. Install the PCI riser and adapters if removed.
8. Replace the cover, and connect the cables. See "Closing the cover and
connecting the cables" on page 24.
Note: When the computer is turned on for the first time after battery
replacement, an error message might be displayed. This is normal after
replacing the battery.
9. Turn on the computer and all attached devices.
passwords.
Important
Before you install or remove any component, read "Important safety
information" on page v. These precautions and guidelines will help you work
safely.
and from the computer.
the system board" on page 13.
Note: Make sure you note the location of the cable that you disconnect from
the system board.
Note: You may need to slightly flex the side of the computer to aide in
removing the speaker.