Preparing the Answering System
Day and Time
Voice Day/Time Stamp: During playback, a synthesized voice will
announce the day and time that each message was recorded.
Make sure the unit is not being used and the handset is lifted off the
base unit.
1
Press
(FUNCTION/2WAY!REC)
Scroll to "Program" by pressing
2
Press
3
á
Press
4
á
5
Press
á
•"Set time" is announced from the base unit.
If previously adjusted, the day/time will be heard.
6
Enter the current time (hour and minute)
using a 4-digit number.
(Ex. To set 9:30, enter "0930".)
7
Press
(*)
Press
(#)
8
Press
á
•The base unit announces the day/time. The clock
starts working.
•If 6 beeps sound from the base unit, the setting is
not correct. Start again from step 5.
•To exit the programming mode, press (OFF)
•You can exit the programming mode any time by pressing (OFF)
•In step 6, you cannot enter numbers greater than 12. Do not use military time.
(To set 13:00 hours, enter "0100", and select "PM" by pressing (*).)
26
.
at "TAD program".
at "Day and time".
to select "AM" or "PM".
repeatedly to set the day.
(Save key).
.
or
.
Ö
Ñ
.
Ringer pattern
H
Program
--------------
--------------
H
TAD program
Set flash time
--------------
H
Day and time
Remote code
SUN 12:00 AM
#=Day
0-9=Time
H
=AM/PM
=Save
SUN 09:30 AM
#=Day
0-9=Time
H
=AM/PM
=Save
MON 09:30 AM
#=Day
0-9=Time
H
=AM/PM
=Save
MON 09:30 AM
.