Dodge 2009 Charger Owner's Manual page 150

148 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
2. Place the hand-held transmitter 1 to 3 in (3 to 8 cm)
from the HomeLink buttons while keeping the EVIC
display in view.
For optimal training, point the battery end of the hand-
held transmitter away from the HomeLink .
3. Simultaneously, press and hold both the chosen
HomeLink button and the hand-held transmitter button
until the EVIC display changes from "CHANNEL #
TRAINING" to "CHANNEL # TRAINED."
Then release both the HomeLink and hand-held trans-
mitter buttons.
If the EVIC display states "DID NOT TRAIN" repeat
Step 3. If the signal is too weak, replace the battery in the
original hand-held transmitter.
It may take up to 30 seconds, or longer, in rare cases. The
garage door may open and close while you train.
NOTE: Some gate operators and garage door openers
may require you to replace Step 3 with procedures noted
in the "Gate Operator/Canadian Programming" section.
4. Press and hold the just-trained HomeLink button. If
the channel has been trained, the EVIC display will now
state "CHANNEL # TRANSMIT."
If the EVIC display still states "CHANNEL # TRAIN-
ING" repeat Step 3.
NOTE: After training a HomeLink
garage door does not operate with HomeLink and the
garage door opener was manufactured after 1995, the
garage door opener may have rolling code. If so, proceed
to the heading "Programming A Rolling Code System."
5. PROGRAMMING A ROLLING CODE SYSTEM
At the garage door opener motor (in the garage), locate
the "learn" or "training" button.
channel, if the