Target Device Tab; Encryption/Compression Tab - HP BB118BV - StorageWorks Data Protector Express Package Addendum

Hp storageworks data protector express 3.5 sp2, software addendum (bb116-90018, october 2007)

Hide thumbs Also See for BB118BV - StorageWorks Data Protector Express Package:

Table of Contents

Target Device Tab

The Target Device tab allows you to select a device for the copy job. Select either the

Device View or the Network View to make your selection. A warning message is

displayed, when the changes are applied, if the device is also being used for the backup

job. This is to help you avoid selecting the same target device for both copy and backup.

By default, encryption and compression settings are inherited from the backup job. Both

may be edited for the Copy job on the Encryption/Compression tab. For example, you

may have disabled encryption for the backup job because media would never leave the

backup device but wish to enable it for the copy job because media will be taken offsite.

Similarly, you may wish to enable hardware compression for the copy job because the

backup did not use any compression. If the backup job was compressed, the default of no

compression should be maintained for the copy job.

Configuring a Copy Policy

Table of Contents

Do you have a question about the BB118BV - StorageWorks Data Protector Express Package and is the answer not in the manual?

Storageworks data protector express