GMC SIERRA 1995 Manual page 425

I
Maintenance Schedule I
-
Diesel Engines
I
27,500 Miles (44 000 km)
0
Change engine oil and filter (or every 3 months, whichever occurs
0
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should not be lubricated unless their temperature is 10" F
(-12" C), or higher. When weather is cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval (or every 12 months, whichever occurs first).
first). An Emission Control Service.
I
DATE
I
ACTUALMILEAGE
I
SERVICED BY:
I
30,000 Miles (48 000 km)
c ]
Change engine oil and filter (or every 3 months, whichever occurs
first). An Emission Control Service.
1
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should not be lubricated unless their temperature is 10" F
(-12" C), or higher. When weather is cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval (or every 12 months, whichever occurs first).
0
For vehicles equipped with a 5-speed manual transmission with deep
low: Lubricate the clutch fork ball stud through the fitting on the clutch
housing. Lubricant must be added sparingly to the fitting, as very little
is required to lubricate the ball stud surface. Do not add lubricant more
often than specified. Too much lubricant w i l l damage the clutch
assembly.
(Continued)
7-69