Cleaning The Inside Of Your Vehicle; Using Foam-Type Cleaner On Fabric - GMC SIERRA 1995 Manual

0
e
0
0
0
0
C/eaning the Inside of Your Vehicle
Use a vacuum cleaner often to get rid of dust and loose dirt. Wipe vinyl
or
leather with a clean, damp cloth.
Your GM dealer has two CM cleaners, a solvent-type spot lifter and a
foam-type powdered cleaner. They will clean normal spots and stains very
well. Do not use them on vinyl or leather.
Here are some cleaning tips:
Always read the instructions on the cleaner label.
Clean up stains as soon as you can
-
before they set.
0
Use a clean cloth or sponge, and change to a clean area often.
A soft
brush may be used if stains are stubborn.
0
Use solvent-type cleaners in a well-ventilated area only. If you use
them, don't saturate the stained area.
0
If a ring forms after spot cleaning, clean the entire area immediately or
it will set.
Using Foam-Type Cleaner on Fabric
Vacuum and brush the area to remove any loose dirt.
Always clean a whole trim panel or section. Mask surrounding trim
along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the directions on the
container label.
Use suds only and apply with a clean sponge.
Don't saturate the material.
Don't rub it roughly.
As soon as you've cleaned the section, use a sponge to remove the
suds.
Rinse the section with a clean, wet sponge.
Wipe off what's left with a slightly damp paper towel or cloth.
Then dry
it
immediately with a blow dryer or a heat lamp.
NOTICE:
Be careful. A blow dryer may scorch the fabric.
~~ ~
0
Wipe with a clean cloth.
6-68