Wheel Removal - DAELIM CITI ACE 110 - CATALOG Manual

WHEEL REMOVAL

[FRONT WHEEL REMOVAL]
1. Raise the front wheel off the ground by
placing a support block under the
engine.
2. Loose the oval screw and remove the
speedometer cable.
AXLE NUT
CAUTION
●Do not operate brake lever after the
front wheel is removed. If will make
wheel assembling difficult.
3. Remove the front caliper assembly
from the fork by removing the fixing
bolts.
4. Loosen the axle nut.
5. Withdraw the front wheel axle and
remove the front wheel.
SPEEDOMETER
CABLE
FRONT CALIPER
6. Install in the reverse order of removal.
OVAL SCREW
●When installing the wheel, carefully
fit the left brake disk between the
brake pads to avoid damaging the
pads.
FRONT WHEEL AXLE
CAUTION
●Prior to assembling, match the
depressed part( ) of the speedometer
gear box with the projected part of the
left front fork.
●Fit the caliper over the disk, taking care
not to damage the brake pads. Install
the caliper fixing bolts, and tighten to a
torque of : 2.7kgf.m
●Tighten the front axle nut to the
specified torque.
FRONT AXLE NUT TORQUE :
5.0~7.0kgf.m
●After assembling, operate brake for a
number of times and see if wheel is
turning smoothly without getting
interruption.
WARNING
●If a torque wrench was not used for
installation, see your authorized dealer
as soon as possible to verify proper
assembly.
Improper assembly may lead to loss of
braking capacity.
39