Changing Engine Oil - DAELIM CITI ACE 110 - CATALOG Manual

CHANGING ENGINE OIL

If engine oil is polluted, it seriously
affects the engine life span. Maintain
appropriate level of oil, use correct type of
oil and observe oil exchange period.
●Stand vehicle on the main stand on
level ground and run engine idle (warm
up) for approximately 2-3 minutes.
●Stop engine and place a container under
the engine. Remove oil level gauge and
drain plug bolt, and drain engine oil.
●Tighten the drain plug bolt.
DRAIN BOLT TORQUE:
●Fill the crankcase with the recom-
mended grade oil.
OIL CAPACITY : 0.75
●Start the engine and keep it idle for a
few minutes.
●Stop the engine and check the oil level.
If the oil level is low, add the recom-
mended engine oil.
●Check on oil leaks.
WARNING
●Be sure to keep oil away from children
and pets. Dispose of used oil properly
34
2.0-3.0kgf· · m
OIL LEVEL GAUGE
UPPER
LEVEL
LOWER
LEVEL
DRAIN PLUG
<RECOMMENDED OIL>
If oil sold on markets or privately-
manufactured oil (low-grade) is used,
engine life is adversely affected, and the
privilege of warranty repairs cannot be
guaranteed.
GRADE (SE, SF, SH)
CAUTION
●If you change engine oil immediately
after engine is stopped, be careful of
burns because the engine, muffler
and engine oil are still hot.
●Exercise caution not to allow dust or
other foreign matter to flow in when
refilling engine oil.
●If oil level is lower or higher than
prescribed level, engine is adversely
affected.
●Do not mix oil with those of different
manufacturers or grade, or do not use
low-quality oil as it may cause
deterioration of oil, leading to
accidents.