TP-Link TL-WR743ND User Manual page 86

reach a specific host or network.
To add static routing entries, follow the steps below.
1. Click Add New... shown in Figure 4-60, you will see the following screen Figure 4-61.
2. Enter the following data.
Destination IP Address - The Destination IP Address is the address of the network or
host that you want to assign to a static route.
Subnet Mask - The Subnet Mask determines which portion of an IP Address is the
network portion, and which portion is the host portion.
Gateway - This is the IP Address of the gateway device that allows for contact between
the Router and the network or host.
3. Select Enabled or Disabled for this entry on the Status drop-down list.
4. Click the Save button to make the entry take effect.
Click the Delete button to delete the entry.
TL-WR743ND
Figure 4-60 Static Routing
Figure 4-61 Add or Modify a Static Route Entry
150Mbps Wireless AP/Client Router
- 79 -