Symantec ALTIRIS DEPLOYMENT SOLUTION 7.1 - V1 Manual page 68

68 Imaging computers
Error 10010
On the client computer, Ghost reports an error message similar to the following
statement:
Error 10010: Cannot open image file \\SITHSITESVR2\DEPLOYMENT\TASK
HANDLER\IMAGE\58A46937-EE86-40A3-B288-16FDB5DE9018\XPT EST.GHO
[WIN32 error:(0x00000003) The system cannot find the path specified.]
The client computer usually only reports that the Failed Deploy Disk
Image_DeployImage task failed.
RapidDeploy uses logs (rather than the onscreen errors that Ghost reports). If an
image does not exist on the site server that it is registered with, you might see
error logs.
See "rd2D7C26.txt" on page 81.
See "ClientImaging_Task.txt"
Error 10010 could occur if the following conditions were met:
A Symantec Management Console server exists in your environment that has
multiple site servers.
The source of a successful Capture Disk Image job of Computer 1 to site server
1 is set at
\\SiteServer1\Images\GUID
The administrator creates a Deploy Image job to Computer 2, which is registered
with site server 2.
The task is scheduled before you use the All Settings option in the Symantec
Management Console and before you choose to replicate the disk image.
In this case, the client computer cannot execute the command because the image
is not yet on site server 2. It exists only on site server 1 until it has properly
replicated throughout each site.
You might also see this error if the task started before the image was replicated
from the parent site to the child site. In this case, you might see this error at a
child site in a hierarchy.
on page 82.
.