Fail Safe(F/S) Function Setting 8 - THUNDER TIGER TOMAHAWK SC Manual

6
FAIL SAFE(F/S) FUNCTION SETTING
ACE RC COUGAR 2.4GHz R/C system features a built-in Failsafe function to automatically set a servo command if the receiver
loses the signal from transmitter due to interference. For safety, we strongly recommend to active the FAILSAFE function on
your Cougar R/C system.
Setting up the Failsafe (F/S) Function:
a. After binding the transmitter and receiver, you can continually set up the F/S function. Turn on the transmitter power and then
receiver power.
b. Press and hold the "Binding SW" button on the receiver for 10 seconds. The LED will start flashing GREEN on the receiver.
CAUTION: Do not release the "Binding SW" button on the receiver until STEP C is completed.
c. Move and hold the throttle trigger to the position you want the control to be in if a failsafe condition should occur. First, keep
steering wheel at neutral position steering servo at neutral position . To set up F/S function with the throttle servo position
at "Brake", first push the trigger to the brake position and hold. To set up F/S function with servo position at "Neutral", keep
the trigger at neutral position.
NOTE: Always set the throttle trigger to neutral or full brake position and steering servo to neutral position in case of any
unexpected control error!
Factory pre-settings for RC car F/S function are :
Electric Car- Steering servo at neutral, throttle at neutral.
Nitro Car- Steering servo at neutral, throttle at iddle and car brakes.
d. After the Step C, release the "Binding SW" button on the receiver first and then the throttle trigger. The LED turns to solid "RED"
and then back to solid "GREEN" indicating the F/S function has now been activated.
e. Test by turning off your transmitter and watching the servo failsafe position activate.
F/S at "Neutral" : To check the fail safe is working properly, by moving the throttle trigger to the full forward (full brake), hold
this position and then turn off the transmitter. The F/S function should move the throttle servo to "Neutral" position and the
steering servo to "Neutral" position.
F/S at "Brake" : To check the fail safe is working properly, by keeping the throttle trigger at neutral and then turn off the
transmitter. The F/S function should move the throttle servo to "Brake" position and the steering servo to "Neutral" position.
f. If the F/S function fails or need to change the F/S hold position, repeat the steps a) ~e). After the F/S is completed, you can
start normal operation.
CAUTION: ALWAYS reset FAILSAFE function after binding your transmitter & receiver.
ACE RC COUGAR 2.4GHz
a.
b.
C
c.
F/S
F/S
:
-
-
d.
e.
F/S
F/S
f.
10 LED
F/S
:
:
F/S
LED 2
F/S
F/S
F/S
F/S