Levelling; Hydraulic Connection - Kelvinator KF224 Instructions Manual

Levelling

Level the appliance by loosening or tightening
the feet. Once in the right position fix the feet by
turning the nuts against the base of the case.
Accurate levelling will prevent vibration, noise
and displacement of the appliance during
operation.
Some vibration is inevitable, especially if placed
on a wooden floor. Wooden floors are
particularly susceptible to vibrations. For advice,
consult a builder. If posible always place the
appliance on a solid floor.

Hydraulic connection

There should be a COLD WATER tap near the
washing machine with a screw on connection
pipe of 3/4 gas for the water supply, a sink, a
wash basin or a drainage system in the wall.
Previously check that:
— it is not a hot water tap.
— the running water is clean. If not, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Have the permanent drainage system in the wall
checked by a plumber.
Place the enclosed rubber joint, delivered in a
plastic bag together with the appliance (A), at the
very end of the inlet hose and carefully screw the
pipe to the tap taking care not to damage the
screwdrive and fix the nut well on to the end in
order to avoid leaking.
If necessary turn the hose adequately by
unscrewing the nut at the rear of the appliance.
Now retighten the nut to avoid leaks. (Open the
tap and assure that it does not leak and close it
again.)
Place the discharging hose in a washbasin or
sink with the aid of the bent piece delivered
separately. The bent piece has to be inserted
into the tube's mouth in order to assure support.
This piece allows the hose to be fixed to the wall
by means of an opening in the upper part and
that way the hose does not move and its falling
is avoided.
6
P0254
A
AL013
P0021
P0022
P0509