Kelvinator KF224 Instructions Manual page 11

6. Start
Before pulling the program selector check if:
The door is properly closed.
The appliance is plugged in.
The water supply tap is turned on.
The drain filter is tight.
The drain hose is adequately positioned.
Pull the program selector towards you till it clicks.
The on/off lamp comes on and the program will
begin.
7. Stop
The washing machine stops automatically once
the cycle is finished, the on/off lamp goes off.
Open the door 3 minutes after the end of the
program to give the safety device time to
unlock.
Push the program selector in, turn off the tap,
and unplug the appliance. Leave the door ajar for
a few minutes for the steam to get out.
IMPORTANT REMARK: This appliance is
provided with a security device to avoid
opening during the cycles. Open it only
when absolutely necessary and wait 3
minutes after you have stopped the
machine to give the safety device time to
unlock.
AL041
11