Installation; Transit Security Bars - Kelvinator KF224 Instructions Manual

Installation

Transit security bars

Before starting the machine up, the transport
security bars must be removed as follows:
You are advised to keep all the transport security
bars in case the appliance has to be transported
again.
Unscrew and remove the three rear screws by
means of a spanner.
Lean the appliance back on the rear and fit one
of the polystyrene angles between the appliance
and the floor.
Make sure the hoses are not squashed.
Carefully remove the plastic bags on the right
and the left, pulling them towards the centre of
the appliance.
Place the machine in an upright position and
remove the three plastic bolts. (Fig. 4).
Plug the 3 holes with the plastic plugs enclosed
in the envelope containing the instruction
booklet. (Fig. 5).
P0287
P0018
1
2
AL009
P0001
Fig. 4
P0002
Fig. 5
5