Installing A Simple-Swap Serial Ata Hard Disk Drive - Lenovo 643815U Installation Manual

Table 2. Locations of hard disk drive IDs
3.5-inch drive model servers
2.5-inch drive model servers
Attention:
cover is in place and fully closed whenever you install or remove a hard disk drive.

Installing a simple-swap Serial ATA hard disk drive

Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To install a simple-swap Serial ATA hard disk drive, complete the following steps.
Note: If you have only one hard disk drive, install it in the left drive bay.
Attention:
cover is in place and fully closed whenever you install or remove a hard disk drive.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Make sure that the server cover is in place and fully closed.
3. Turn off the server and peripheral devices, and disconnect the power cord and
4. Remove the filler panel from the bay.
5. Pull the loops of the tray toward each other and slide the drive into the server
16
ThinkServer RS110 Types 6435, 6436, 6437, and 6438: Installation Guide
To avoid damage to the hard disk drive connectors, make sure that the
Simple-swap hard disk drives are not hot-swappable. Disconnect all
1
SATA hard disk drive back plate
2
Filler panel
To avoid damage to the hard disk drive connectors, make sure that the
on page 11.
all external cables.
until the drive connects to the back panel.
3
Hard disk drive assembly