Table of Contents
Advertisement
support.dell.com
To install the slide assemblies in the rack, perform the following steps:
1.
Place the front of the template on the vertical rails at the front of the rack where
you want to install the appliance.
Ensure that the printing on the template identifies the side facing outwards as
the template front.
Position the bottom of the template in line with the desired bottom position of
the computer chassis.
2.
Mark the rack's front vertical rails with a felt-tipped marker or place masking tape
where the appliance's upper and lower edges will be located (see Figure 1-16).
Make a mark or place tape on the vertical rails next to the template's V-shaped
notches.
1 U (1.75 inches) between
slide assemblies
(drawing is not to scale)
1-U template
Figure 1-16. Using Template to Mark Vertical Rails
Rack Installation Guide
1-19
Advertisement
Table of Contents
