Table of Contents
Advertisement
support.dell.com
3.
Remove the front door from the rack as shown in Figure 1-14.
a.
With the door open, lift out and fully retract all hinge pins.
b.
Once all the hinge pins have been lifted out and retracted, lift the door out.
hinge insert
Figure 1-14. Removing the 24-U Rack Doors
CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
If you want to reverse the door so that the handle is on the other side, perform the
following steps:
1.
With the door open, lift out and fully retract all hinge pins.
2.
Remove the hinges and door brackets from the door frame.
3.
Replace the hinges and door brackets on the opposite side and switch the
position of the handle.
4.
Replace the rack door (see the section, "Replacing the Rack Doors" , found later in
this guide).
hinge pin
hinge
Rack Installation Guide
1-17
Advertisement
Table of Contents
