Asus TR-DLSR User Manual page 30

3. HARDWARE SETUP
2) IDE/SCSI Activity LED (2-pin IDELED)
This connector supplies power to the chassis activity LED. Read and write activity
by devices connected to the primary/secondary IDE and SCSI connectors cause
the LED to light up.
NOTE: Another 2-pin IDE LED connector is available in the connector
labeled PANEL.
TR-DLSR IDE Activity LED
3) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connecting
the single end to the board, connect the two plugs on the other end to the floppy
drives. (Pin 5 is removed to prevent inserting in the wrong orientation when
using ribbon cables with pin 5 plugged).
TR-DLSR Floppy Disk Drive Connector
30
IDELED
TR-DLSR
TR-DLSR
ASUS TR-DLSR User's Manual
*Same as the "HDD Access
+ - LED" in the panel connectors
PIN 1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.