Electrical And Fuel Inlet Locations; Lifting The Generator - GE HOME GENERATOR SYSTEM 11000 WATT Installation And Start-Up Manual

Electrical and Fuel Inlet Locations

The 3/4 inch N.P.T. fuel inlet connector
B
location is shown at right.
The home generator is shipped already attached to its
mounting pad. Unless mandated by local code, a concrete
slab is not required.

Lifting the Generator

The generator weighs more than 240 kg (530 pounds). Proper
tools, equipment and qualified personnel should be used in
all phases of handling and moving the generator.
WARNING Hazardous Voltage - Contact with power lines could
cause electric shock or burn, resulting in death or
serious injury.
Lifting Hazard / Heavy Object - Could result in
serious injury.
• If lifting or hoisting equipment is used, DO NOT contact any
power lines.
• DO NOT lift or move generator without assistance.
• Use lifting pipes as described in Lifting the Generator.
• DO NOT lift unit by roof as damage to generator will occur.
Two 48" lengths of 1" pipe
required to lift the generator manually. Insert pipes through
D
the lifting holes located near the unit's base.
You may also lift the unit using a "hook and hoist" method
attached to the lifting pipes, provided that you use a
spreader bar to ensure that the chains or cables DO NOT
touch the generator's roof.
A
and electrical inlet
C
, supplied by the installer, are
B
A
After unit is in place, fill the lifting holes with the supplied
lifting hole plugs.
D
C
15