Dish Network 167820 User Manual page 37

What's
What's Wrong
Happening
Your remote • The remote control
control isn't is in the wrong
working mode.
• You might be
using the wrong
remote control
(TV1 or TV2).
• Your batteries are
worn out.
• The remote
control's A/B
switch is in the
wrong position.
When you press • The remote control
the remote may not be set up.
control MUTE
or VOLUME
button, nothing
happens.
• Maybe you're
trying to control
TV volume but
you set up the
remote to control a
tuner or amplifier
in AUX mode.
Your UHF Pro You may be
remote control experiencing
does not work interference from
well from far objects near your
away. receiver antenna.
Your PIP • Your receiver
(Picture-In- doesn't use PIP.
Picture) button
• Your receiver isn't
isn't working.
in Single Mode.
What You Can Do
• Make sure the remote control is in the
correct mode. For example, if you want
to use the satellite receiver, put the
remote control in SAT mode (see
Remote Control Modes on page 1).
• Make sure you are using the correct
remote control (TV1 or TV2) for your
locations (multi-room receivers only).
• Change the batteries as described on
page S-2.
• Check the A/B switch setting as
described on page 13.
For all receivers, except for the
DISH Player-DVR 942, ViP
222, ViP 622 DVR, and ViP
722 DVR, leave the A/B
switch in the A position.
• See Programming the Remote to
Control Your TV on page S-4 and
Programming for Other Equipment on
page 2.
• Set up the remote to control either
TV volume or tuner/amplifier volume,
whichever you want. See page 7.
• Make sure the UHF antenna is
connected to the receiver and not
touching anything else.
• Vary the tilt angle of the receiver's UHF
antenna. Locate the UHF antenna tip
away from other electronics equipment
or metal surfaces, even if separated by
wooden shelving.
• Move the receiver to different
locations. For best results, place the
receiver as high as possible, above all
other equipment in your entertainment
center.
• Place the UHF antenna outside the
entertainment center by using a coaxial
cable to connect it to the receiver.
• Move any nearby off-air antenna away
from the UHF remote antenna. Do not
place an off-air antenna on your
receiver.
• Upgrade to a receiver with this feature.
• Press the MODE button on the front
panel (if available).
25