DirecTV HR20 User Manual page 80

DIRECTV Whole-Home DVR Service
®
2. Activate DIRECTV
®
Once DIRECTV Whole-Home DVR service is activated on your account,
®
press the LIST button on your remote. The message on the right will display,
confirming the service has been enabled. Select "Continue".
Note: Service activation and location naming are typically performed by the
installer during your installation appointment.
3. Name Your Locations:
You'll be prompted to give each receiver a name. We refer to this as
"Location." We recommend using a name that you'll easily associate
with the room or it's location, such as, "Living Room." The name must be
14 characters or less. You must be at the receiver to assign its name.
After you've assigned a Location Name, you can change it as follows: Press
MENU, select "Parental, Fav's & Setup," "System Setup," "Whole-Home" and
then "Name Location."
DIRECTV DVR
® USER GUIDE
80
(High-Definition Receivers)
Whole-Home DVR Service: