Available Functions For Sony Visca Cameras - Sony RM-BR300 - Remote Control Unit Operating Instructions Manual

Switch position
5
6
7
Notes
• Use position 1 to 7 when all the connected
cameras are of the same model. In other cases,
use position 0.
• Be sure to use position 5 for the SNC-RZ30N/
RZ30P.
V VISCA RS-232C connector
Connect to the VISCA RS-232C IN connector of
the camera or the Optical Multiplex Unit.
W VISCA RS-422 connector
Connect to the VISCA RS-422 connector of the
camera or the Optical Multiplex Unit.
An RS-422 connector plug is attached at the
factory.
X TALLY/CONTACT connector
This connector is used for the tally lamp input or the
contact output.
Select the function of the connector using the
TALLY/CONTACT selector.
An RS-422 connector plug is attached at the
factory.
Y TALLY/CONTACT selector

Available Functions for Sony VISCA Cameras

The functions of the controls, buttons and connectors in the following list differ depending on the connected camera
model. The functions of the other parts are the same for all the camera models.
Parts
B VALUE/R control
C BRIGHT/B control
G ONE PUSH AF button
L PAN-TILT RESET button
N MENU button
R POWER button
S CAMERA buttons
W VISCA RS-422 connector
: available, × : not available
a
8
GB
Location and Function of Parts
Camera mode
SNC-RZ30N/RZ30P
BRC-H700
BRC-Z700
BRC-300/
300P, BRC-
H700, BRC-
Z700
a
a
a
a
a
a
a
a
Select the function of the TALLY/CONTACT
connector.
TALLY: The CAMERA button of the camera
selected with the connected switcher lights in blue
and the tally lamp of this camera lights.
CONTACT: The contact output corresponding to
the camera address selected with this unit is short-
circuited against the connected switcher.
CONTACT (TALLY): The contact output
corresponding to the camera address selected with
this unit is short-circuited against the connected
switcher and the tally lamp of the selected camera
lights.
wh DC IN 12V connector
Connect the supplied AC power adaptor.
wj DIP switches (bottom)
Switch 1 (RS-232C/RS-422 selector)
Set to ON for RS-422, or OFF for RS-232C.
Switch 2 (Communication baud rate selector)
Set to ON for 38,400bps, or OFF for 9,600bps.
Switch 3 (BRIGHT control function selector)
Set to ON for IRIS and GAIN adjustments, or OFF
for IRIS adjustment only.
wk ON/OFF switch
Press this switch to turn on/off this unit.
Note
Set the switches before you turn on the power of this
unit. Otherwise, the setting is not effective.
EVI-D100/ EVI-D70/
D100P D70P
a a
a a
a a
a a
a a
a a
a a
a
×
EVI-D30/ SNC-RZ30N/
D30P RZ30P
× a
× a
× a
a ×
a ×
a ×
a ×
× ×